Step by Step Process of Installing Complete Septic Pump Stations

Septic pump stations are also known as drainage solutions that are very efficient when it comes to dealing with wastewater and sewage that has resulted from developments that do not have a primary sewer connection. Having a piece of in-depth knowledge about it is crucial when it comes to installing the system and the pumps since it plays a vital role in your infrastructure. Septic pump stations are used for pumping air in systems from a higher to lower elevation specifically where the source that is elevated is not enough for gravity to flow.

The Six Essential Steps

1. Perform a Percolation Test

Learn to do a site survey. It will specify and stipulate the permeability of your soil and the number of feet of field lines that will be installed.

2. Design your Septic System

It is significant for you to have a clear and established plan and design before installing your septic pump stations. The design will be based on the findings of your survey and the results of your percolation test. Large amounts of water move in it, why is why you have to consider the effects of rainfall and suitable pump sizing. Your design must be inclusive of your findings such as the available space, primary objective, soil type, water use, topography, devices, and more.

3. Apply for Permits and Approvals

Before digging your own holes and trenches at home or at a specific development, you should understand what you are doing and ensure that the entire process will be done legally and precisely.

4. Select the Right Materials

Choose the proper materials and durable pumps for you to accurately build your pump stations for a successful long-term operation. Must be equipped with lift pumps, pipes with valves, equipment control panel, and a junction box.

5. Installation

You can do it yourself but you can also hire a professional to ensure safety and efficiency. Installing septic pump stations requires at least 2 feet deep. Measure the distance from the top of the place of entry until the bottom of the pump. Dig a hole that is sufficient and huge enough for you to place the pumps below the ground. You can go deeper and further if necessary.

6. Maintenance and Accessibility

You have to consider the future maintenance of your septic pumps. The pumps must be accessible at all times for inspection that will ensure that your system is running properly.

Your sewage system plays a major part in your house or any type of infrastructure. In order to avoid any complications, it is highly recommended for you to make sure that your septic pump stations are installed properly. Be sure to perform the following procedures above in compliance with the laws and applicable plumbing and building codes.

Have your say